Control Relays

- Relays are suitable for use on alternating current (ac) control circuits up to 600 volts, and dc control circuits up to 240 Volts.
- All terminals are marked in accordance to EN50011.
- Control relays may be mounted on 35mm DIN rail EN50022-35, or may be panel-mounted using two or four #8 screws in diagonal corners.
- Screw and quick-connect terminals are protected against accidental contact in accordance with VDE0106T.100 and VBG4.
- Low-coil wattage requirement makes relay ideal for most applications. (24 Vdc PLC interface versions are available.)
- A wide range of accessories, including front-mounted auxiliary contact blocks, side-mounted auxiliary contact blocks, a timer, and surge suppressors, are easily installed on relays.

PLC Compatible Control Relays

Low Coil Wattage Control Relays

While the standard line of MCRC dc operated relays requires only 3 watts coil holding current, some PLC applications require lower wattage coils to efficiently interface with the PLC. Special relays are available with 24 Vdc coils which only require 1.2 or 2 watts for pull in and holding. These relays are available with screw terminal configuration.

- All terminals are dual marked in accordance to EN50012, and U.S. marking standards.
- Relay may be mounted on 35mm DIN rail EN50022-35, or may be panel-mounted using two #8 screws in diagonal corners.
- Screw-type terminals are protected against accidental contact in accordance with VDE0106T.100 and VBG4.

Contact Rating A600, Q300

Standard Screw
2x2.8mm Faston
1x6.3mm Faston
PC Board

Contact Rating A600, Q300

Standard Screw
2x2.8mm Faston
1x6.3mm Faston
PC Board

Contact Rating A600, Q300

Standard Screw
2x2.8mm Faston
1x6.3mm Faston
PC Board

Contact Rating A600, Q300

Standard Screw
2x2.8mm Faston
1x6.3mm Faston
PC Board

Contact Rating A600, Q300

Standard Screw
2x2.8mm Faston
1x6.3mm Faston
PC Board